MODEL 71230
2-1/4 TON CAPACITY

INTENDED USE
A heavy duty floor jack designed for a variety of automotive shop uses where additional strength and dependability are required.
FEATURES
  • Steel hydraulic block assembly includes dust seals to prevent oil contamination.
  • Long, removable two piece handle with rubber hand grip provides: Ease of pumping - Longer reach for positioning under overhang - Ease for transportation and storage - Ease of pumping in tight quarters when second handle section is removed.
  • 3-3/4" low lift height
  • Safety by-pass system protects pressure cylinder.
  • Safety overload system prevents jack from being used beyond its rated capacity.
  • Heavy duty chassis for added strength and dependability.


MODEL 71155
1-1/2 TON CAPACITY

INTENDED USE
Lift and position a vehicle on tall jack stands, frame straightening racks or alignment systems. All purpose use in PBE applications.
FEATURES
Similar to that of the model 71230 with the following exceptions:
  • 32" maximum lift with 18" wide stance foot print provides a strong stable lifting platform.
  • 4-3/4" square polyurethane covered saddle for better grip and vehicle frame protection.
  • Additional foot pedal pumping feature provides fast saddle raising to the load.
  • Controlled load lowering by pulling "T" handle and rotating clockwise 1/4 turn.


OPTIONAL EQUIPMENT
MODEL 71156
1-1/2 TON CAPACITY CROSS BEAM ADAPTOR

Fits the model 71155 floor jack only.
FEATURES
  • Provides additional lifting stability by distributing the load to two adjustable saddles from 23" to 32" on center.
  • Lifts FWD vehicles without the axle beam.
  • Threaded saddle stems allow 2" of elevated adjustment on each saddle.
  • Polyurethane covered 4-3/4" square saddles for better grip.
  • Lifts vehicles at rocker panels for simultaneous tire change.


MODEL 71500C
5 TON CAPACITY

INTENDED USE
Truck fleet, truck and farm equipment dealers and bus company garages.
FEATURES
  • Chromed ram and dust seals prevent hydraulic contamination.
  • Safety by-pass and overload systems protect hydraulic block.
  • Additional foot pedal pumping provides fast saddle raising to the load.
  • Spring loaded "T" handle can be activated to lower load in any handle position by pulling and rotating it clockwise 1/4 turn.
  • High carbon steel chassis provides maximum strength in a lightweight jack design.



MODEL 71550A
5 TON CAPACITY

INTENDED USE and FEATURES
Same as the model 71500C but with the added convenience of a push button operated air/hydraulic pump. Operates manually or with air.

MODEL 71000B
10 TON CAPACITY		 MODEL 72220
20 TON CAPACITY
INTENDED USE
Heavy duty truck, heavy construction and agricultural equipment maintenance garages.
FEATURES
  • Same as model 71500C but model 72220 has a locking release lever that locks the handle in the vertical, 45 degree or horizontal position to lower load.

* Note: Model not shown has same basic construction as model pictured.


Click here for dimensions