MODEL 72500C
1/2 TON CAPACITY
SINGLE PUMP

INTENDED USE
 Designed for the removal, installation and transportation (in the lowered position) of transmissions and transfer cases on passenger cars, vans and light trucks that are raised by an in-ground or above-ground lift.
FEATURES
  • Fully adjustable universal saddle with adjustable corner brackets and safety chain.
  • Safety overload system prevents jack from being used beyond its rated capacity.
  • Foot operated pump and lowering pedals allow use of both hands to position and align saddle with transmission.
  • Two-stage flash chromed rams inhibit rust from entering hydraulic system.
  • Wide base with four 3" diameter swivel ball bearing caster wheels, provides stability and easy maneuvering.


MODEL 72550
1/2 TON CAPACITY
AIR and HYDRAULIC

INTENDED USE
 Designed for the removal, installation and transportation (in the lowered position) of transmissions and transfer cases on passenger cars, vans and light trucks that are raised by an in-ground or above-ground lift.
FEATURES
  • Same as model 72500C but with 2 times faster rising action without load.
  • 2 times faster rising action with a load up to 500 pounds.
  • Same rising action as model 72500C for loads between 500 and 1,000 pounds.


MODEL 72400A
1/2 TON CAPACITY
DOUBLE PUMP

INTENDED USE
 Same as model 72500C but with a double pump piston design that raises the jack to the load and raises the load twice as fast as any single pump design.
FEATURES
  • Pneumatic primary stage for fast rising is activated by depressing a foot pedal.
  • Safety by-pass system prevents the ram from being overextended and causing damage to the cylinder.
  • Air and hydraulic rams are flash chromed to inhibit rust.
  • Fully adjustable universal saddle with adjustable corner brackets and safety chain.
  • Wide base with four 3" diameter swivel ball bearing caster wheels provides stability and easy maneuvering.


OPTIONAL ADAPTERS, HANDLER and SADDLE
Fit models 72050C, 72500C, 72550 and 72400A transmission jacks.

MODEL 72520
FWD SUBFRAME HANDLER

INTENDED USE
 An optional saddle that handles the removal and installation of all front wheel drive vehicles' subframes.
FEATURES
  • Removal and installation can be accomplished with one person.
  • Four rotating telescopic arms easily adjust to any subframe hole mounting configuration.
  • Quicklock wing nuts secure telescopic arms at their required lengths.
  • Four threaded studs quickly adjust to the contour, height and location of the subframe mounting holes. Weight: 36 lbs.


MODEL 72525
QUICK ADJUST SADDLE

INTENDED USE
 An optional saddle that replaces the four adjustable corner brackets found on the standard universal saddle.
FEATURES
  • Quickly adapts to the existing universal saddle plate.
  • Four low profile ratcheting arms quickly and easily adjust to the transmission pan configuration. Weight: 9 lbs.


ADAPTERS

MODEL 72501B
For use on GMC 4WD transmission case. Weight: 18 lbs.
MODEL 72502B
For use on 4 and 5 speed truck transmissions. Weight: 13 lbs.
MODEL 72504B
For use on GMC front wheel drive transmissions. Weight: 24 lbs.
MODEL 72505B
For use on GMC front wheel drive transmissions (X, J & A bodies) 3T40. Weight: 158 lbs.
MODEL 72506B
For use on GMC 440 metric transmissions 4T60-E. Weight: 11-1/2 lbs.
MODEL 72507
For use on Ford E40D truck transmissions. Weight: 34 lbs.


Click here for dimensions